RF-51 High Quality Rubber Roof Flashing

RF-51 Round Base

1 3/4"-3 1/4" (45~85mm)

Silicon with 2pcs stainless steel on the base

Support OEM

Pipe OD Range 0-150mm

Angle(from 10 to 45 degree)

The temperature resistance(high and low)for EPDM Roof flashing is from -50 to 160

Silicone Roof flashing is -60 to 200

EPDM/Silicone with or without AL.Plaiting

Excellent resistant to weathering

Flame resistant,ozone resistant,oxygen resistant

High tensile strenth and high elongation

Covered thirty year warranty

A=Top Opening Diameter

B=Overall Height

C=Base Dimensions

For more effective drainage Roof Flashing are suitable for all installations

apply silicone sealant

Cut a hole in roofing sheet and opening at least 20% smaller than pipe diameter with minumum clearance for pipe and insert pipe through hole

press roof profile and smooth out creases

Slide flashing down over pipe using water and allow the pipe to side snuggly into position

fasten flashing using washered screws or sealed rivets

Tags:

Technical Support: